OK so i don't keep it as clean as yours BUT, that's because i catch fish and clean them on the deck. Big fish !! so big i can't just pick them up and hold them over the side and clean them. 😛
I wanted to label the wires. Found a tip on the "hulltruth" that was inexpensive and simple. I printed the numbers on peel and stick labels, then cut them to size. Stuck them to the wire and slipped a piece of clear heat shrink tube over it.
View attachment 18437
Very nice looking electrical work.I did mine a few years most of which had to be done in place.This is mostly just the electronics.View attachment 18439View attachment 18440View attachment 18440
Very nice looking electrical work.I did mine a few years most of which had to be done in place.This is mostly just the electronics.View attachment 18439View attachment 18440View attachment 18440
Here's a picture as to why I'm jealous. This is what came out of the factory with minimal electronics, 2 bilge pumps, radio, Garmin GPS/Sounder/Radar unit, Nav Lights, Cabin Lights, Cockpit Lights, bayonet 12V plug. The wash down pump is not tied in here.
It's not too bad ..... I have seen way worse.
I'm going to have to sand the rest of the original deck. It's going to be a PIA. They used regular sand mixed with gel coat for the original no skid. Its done a number on my circular and sawsall blades and takes out a new sanding disk in no time.
It's not too bad ..... I have seen way worse.
Sign in to reply to this thread.